FAQ

When the program is not running

1.1 Execution Rights Issues

1.2 Program Internal Error



When I can't download it

2.1 Program does not exist

2.2 When the download is not complete

2.2.1 When using the Bluetooth module



When the robot is not working


▶ When the program is not running


_____________________________________________________________

1.1 Execution Rights Issues

Depending on the settings on some PCs, you may need permission to run the program.


This can be resolved by right-clicking on the installed logic icon and "executing with administrator privileges".

1.2 Program internal error

A file inside the program may be damaged and not functioning normally.

If you receive the following or similar error messages when you run a program, you can resolve them by deleting and reinstalling the program.

▶ When download is not possible

_____________________________________________________________

2.1 The Program does not exist

This is an error that occurs when you try to download the robot without writing the program. You can write the program by attaching another chip to the "Start" chip.


1. This is the first screen of the Rogic program. No program is currently written.

 

2. I took out the "DC Motor" chip and put it under the "Start" chip. However, the program was not written because the connection mark did not appear.

 

3. In order for a program to be written, a chip must be attached to display a connection indication between each chip. After you have finished writing the program, you will try to download it again.


2.2 If download cannot be completed

When using the Bluetooth Module


If the Bluetooth board is connected to the RoboKit CPU, the download will not proceed normally.

If the Rogic stops during the program download and the download does not complete, make sure that the board is connected to the RoboKit CPU, as shown in the following photo,

You must remove the connection and proceed with the re-download.


Bluetooth Board

Wireless Board


▶ When the robot is not operating

Replace the battery and make sure the power is on.

Ensure assembly and connection are correct.

Make sure that the robot is programmed.

Download the program.

Press the Run button.



Try again in the order above.